1 Operation:
Before each use: if necessary, unscrew the stainless steel fi lter at the bottom of the recovery tank and clean
it. Also make sure the fl oat in the recovery tank is clean.
• Attach a 3/4” garden hose to the dump pump outlet fi tting on the back of the base of the machine.
Refer to illustration below.
• Run the other end of the hose into a drain.
• Turn ON the dump pump switch (switch is located on the switch panel on the top of the machine).
• NOTE: the dump pump is ‘self-priming.’ You should see water start to fl ow within 30 seconds of the
pump turning on. If water does not begin to fl ow, check the fi lter to see if it is plugged with debris.
After each job: run clear water though the dump pump to wash out any chemical residue.
Remove and clean the stainless steel fi lter in the bottom of the tank. Reinstall the fi lter once it is
clean. Clean and empty the recovery tank
.
AUTO-DUMP
DANGER: always unplug the King Cobra from the electrical outlet(s) before
cleaning or maintaining. Certain internal components are electrically live,
even with switches in their OFF position.
Dump
Pump
Drain Hose
AUTO-DUMP
Power
Prime
Hose
DANGER: DO NOT USE SOLVENTS, OR ANY CHEMICALS THAT MAY BE
FLAMMABLE, EXPLOSIVE OR COMBUSTIBLE.
CAUTION: always use a defoamer in the recovery tank to prevent water or
foam from entering the vacuum motor.
Dump Hose
Connection
(on pump)
8
Power
Prime
Pedal
https://harrissupplyind.com - To Order Parts Call 608-268-8080
