6
SOLUS
®
500R - 56041970
6/07
INSTRUCTIONS FOR USE
A - ENGLISH
KNOW YOUR MACHINE
1 VACUUM
LID
- This lid provides access into your recovery tank so that you can clean the tank. The lid must be closed before you try to clean.
2
SOLUTION TANK FILL HOLE
- This is where you
fi
ll the tank with water and cleaning solution.
3
VACUUM HOSE BARB
- This is where you connect your vacuum hose to the machine. A tight connection is necessary to prevent a vacuum leak which
would reduce the amount of suction.
4 DRAIN
HOSE
- This is how you empty the dirty water from your recovery tank. Place the hose over a drain, and open the cap. When cleaning out the tank
at the end of a job, simply place this hose into a drain and use clean water to rinse out the dirt and debris from the tank.
NOTE
: be sure to close the cap
tightly before using the machine again.
1
2
3
4
5
8
9
10
12
13
6
7
11
11
5
HANDLES -
The handles are used to move the machine. These handles
allow you to tilt the machine back onto its 12” wheels for easy maneuvering,
and/or for moving on stairways.
6 SWITCH
PLATE
- The switches are located on the rear of the machine, out
of the way of water.
7 FAN
- Removes warm air from the component compartment.
8 PSI
GAUGE
- indicates the pump pressure. Look at the pressure while you
spray.
9 LATCH
- The latch holds together the tank and the base compartment.
10 SOLUTION HOSE QUICK CONNECT
- This is where you connect the
solution line that runs from the machine to the carpet wand or hand tool.
11 POWER CORD RECEPTACLES
- The receptacles are where the two power
cords connect to the machine.
12 CASTOR
- Swivel castor provides easy maneuverability.
13 WHEEL
-
The rear wheels are 12 inches in diameter to provide superior
ease of transportation and stair climbing.
Summary of Contents for Solus 500R
Page 32: ......
