Part # 3052000 (09/16/09)
Page 30
8. Remove the two thermostat mounting screws and pull
the thermostat forward.
9. Release the thermostat sensor retaining clips from the
oven lining and the sensor from the clips.
10. Withdraw the thermostat sensor from the oven
compartment. The thermostat should now be totally free
to remove from the appliance.
11. Fit the replacement thermostat and reassemble the unit
in reverse order.
Power Switch
1. Remove the screws securing the front control panel and
pull forward to “unsnap” it from the unit.
2. Disconnect the wires from the terminals on the switch.
3. Depress the tabs on the body of the switch and push the
switch through the panel opening.
4. Fit a replacement switch and reassemble in reverse order,
ensuring wires are attached correctly.
Door Switch
1. Remove the screw securing the front control panel and
pull out on the panel to “unsnap” it from the unit.
2. Remove the cover protecting the door switch.
3. Remove fasteners securing the door switch to the
mounting bracket and remove the switch.
4. Disconnect wires from terminals on switch.
5. Replace with new switch and reassemble in reverse order.
Oven Pilot
1. Remove the screws securing the front control panel and
remove the panel by pulling forward to “unsnap” it from
the unit.
2. Disconnect the thermocouple connection at the gas
valve.
3. Disconnect the pilot connection at the gas valve.
4. Open the lower front panel.
REPLACEMENT OF PARTS Continued
5. Remove the oven bottom assembly plate. (For RC models,
refer to the previous section under burner cleaning.)
6. Disconnect the pilot gas supply pipe at the pilot burner.
7. Remove the screws that secure the pilot mounting
bracket to the oven burner support.
8. Remove the pilot assembly.
9. Replace the faulty component and reassemble the unit in
reverse order.
CAUTION: Don’t over-tighten the connection between the
thermocouple and the flame safety device. It is sufficient for
it to be finger tight plus a quarter of a turn.
Convection Ovens (RC) - Spark Module
1. Remove the screws securing the front control panel and
pull out on panel to “unsnap” it from the unit. Gently set
panel down and ensure its supported.
2. Remove screws from front component support plate and
slide forward.
3. Disconnect the wires from spark module.
4. Remove the screws that secure the module.
5. Replace with a new module and reassemble the unit in
reverse order.
Convection Oven (RC) Motor
1. Remove the oven racks from the oven compartment.
2. Remove the two (2) wing screws securing the fan guard
and remove the guard.
3. Using an Allen key, loosen the screw securing the fan
wheel to the motor shaft.
4. Remove the six (6) screws securing the motor mount
plate to the oven casing back and pull the plate forward
into the oven compartment.
5. Disconnect the wires from the motor terminals noting
which terminal each wire came from.
6. Replace with new motor and reassemble in the reverse
order.
