U.S. Range U.S. Range THE SUMMIT, Installation And Operation Manual

Part # 1955202 Rev 4 (07/13/12)

Page 12

and light its LED. 

Pressing the 

FAN LOW

 will activate the higher fan speed and 

light its LED.

Pressing the 

FAN PULSE

 key the fan will be active the lower 

fan speed and light its LED. The fan will be activated for 30 

seconds then off for 30 seconds, and continues this cycle.

Pressing the 

SETBACK

 key will cool the oven cavity to 

a preprogrammed temperature. (See: Setting “Setback” 

feature). The oven will automatically go into Setback mode 

after the pre-programmed non usage time. The display will 

indicate “

SETB

”. This is an energy-saving feature.

Pressing the 

COOL DOWN

 key will deactivate the heat, turn 

the fan on high and light its LED. This display will indicate 

“

OPEN DOOR

” if the door is closed, prompting the user 

to open the door slightly. With the door open slightly the 

display will indicate “

COOL

”. The Cool down will operate 

when the door is closed or opened slightly. 

Optimal cool-

down will be achieved with the door open slightly

. When 

the door opens wider, the Cool Down mode will deactivate 

and the display will indicate “

DOOR

”. 

This is a patented safety 

feature.

 Pressing the 

COOL DOWN

 key again will turn the LED 

off and stop this mode. Pressing the 

ON/OFF

 key will also 

cancel Cool down. Cool Down is not active during a cook.

When the 

ON/OFF

 switch is pressed to turn the oven off and 

the oven is above 200°F (93°C), the oven will go into an 

AUTO 

COOL DOWN

 mode. In Auto cool Down, the oven will run the 

fan on high until the oven cavity drops below 150°F (66°C). 

During this time the display will indicate “

AUTO

”. When the 

oven temperature drops below 150°F (66°C) the oven turns 

off. This feature protects the oven motor from premature 

failure. 

Optimal cool-down will be achieved with door open 

slightly .

Fahrenheit/Celsius

Factory default is Fahrenheit (F). To change to Celsius (C), 

press and hold in the “Phantom Key” located to the right of 

“Cook/Hold” key. “F” appears in the display. Continue to hold 

until “C” is displayed  and then release the “Phantom key”.

Operating the Controls

Setting the cook temperature and time are done in the same 

manner. Pressing the 

SET 

key will light the 

TEMP

 LED. The 

operator then sets the temperature by rotating the dial on 

the controller until the desired temperature is shown on the 

display. Pressing the 

SET

 key a second time lights the 

TIME

LED and allows the operator to select the desired cook time 

OPERATING INSTRUCTIONS Continued