Part # 4523974 Rev 2 (05/06/14)
Model UIR36C
Page 14
INSTALLATION Continued
Wall Or Counter Mounted Salamanders
1. Clearance from combustible construction must be six
inches (6”, 152mm) minimum at the rear and six inches
(6”, 152mm) minimum at both sides.
The appliance shall be located with respect to building
construction and other equipment so as to permit access
to the appliance. Such access and clearance may be
necessary for service and cleaning.
2. Counter models are furnished with 4” (102mm) legs.
Level the unit with a carpenter’s level and make minor
adjustments with the threaded leg feet. Ensure that the
counter top can support the weight of the appliance
prior to installation and is comprised of non-combustible
material.
3. Provisions for gas connections, top or rear, should be
taken into consideration at time of installation.
4. If the unit is to be mounted on a non-combustible wall
contact the local authorities for local codes.
5. Position, level, and mark location of the assembled wall
mount kit.
6. Drill wall (locating studs if necessary) to accept suitable
fastening devices.
7. Drill the angle iron bars of the wall mounting kit to match
those drilled in the wall.
8. Install wall mounting kit to wall.
9. Install and secure broiler with bolts supplied.
4
INSER
T
E
D
SCRE
W
S
4
INSER
T
E
D
SCRE
W
S
D
E
T
AIL
II
F
OR
60
"
RANGES
W
I
TH
S
T
AN
D
AR
D
O
V
EN
D
E
T
AIL
II
F
OR
60
"
RANGES
W
I
TH
CON
V
EC
T
ION
O
V
EN
3. Slide the salamander down into the support brackets
installed in step 2, see fi gure 3.
4. Once the salamander is in place, fasten it to the unit on
both sides of the range with the provided #14B x 5/8 hex
washer head tapping screws (detail I) and the center to the
support bracket using 4 of the provided screws (detail II).
D
E
T
AIL
I
ALL
60
"
RANGES
PRO
V
I
D
E
D
#1
4
B x
5/8
H
E
X
W
AS
H
ER
H
EA
D
T
APPING
SCRE
W
S
4
PRO
V
I
D
E
D
SCRE
W
S
D
E
T
AIL
II
ALL
60
"
RANGES
