P R E - O P E R AT I O N C H E C K L I S T
5.7
Check for missing or loose bolts. Tighten loose bolts and
re¬place missing bolts before operating machine. Verify that blade
guards are in place. Never operate a MC-45 without guards in place.
5.8 WARNING:
If you can see the diamond blade, the guards are
not in place. Never operate a MC-45 without guards in place. The proper
position for the blade guard is down touching the horizontal surface.
5.9
Dress properly. Wear ear and eye protection. See sections 4.3
through 4.7. See Figure 16
8
R
haz
g
a
Rotating blade hazard.
Do NOT operate with guard up.
Keep hands and feet away.
Figure 7 - Warning label - do not operate with guard
up
AVOID INJURY.
Do NOT operate with guard removed.
Replace guard before operating
machine.
Figure 6 - Warning label - do not operate with
guard removed
Flying debris
and loud noise
hazards. Wear
ear and eye
protection
Wear appropriate clothing
Figure 8 - Warning label - wear proper clothing, ear and eye protection
WARNING:
Recommended accessories for this tool including blades are
listed in this manual or are available by calling customer service. The use of
any other attachment or accessory might be hazardous
5.11
MC-45 premium dry cut diamond blades
U.S.SAWS recommends soft blond blades for use with the MC-45.
Blades can be used in a variety of sizes and spacing options up to 1.5” wide.
4” Blades Part #:TNA04100DF
4.5” Blades Part #: TNA045100DF
5” Blades Part #: TNA05100DF
Blade set up:
Remove the outer blade nut. Leave the inner blade shaft in place. Place the
first blade onto the shaft of the inner blade shaft. Next, place the desired
thickness spacer on the blade shaft on top of the blade. Repeat the process
until the desired width is achieved. Make sure there’s enough spacers in
place to allow the outer blade nut to clamp down firmly on the blade stack.
Surface Prep
Division
P: 877-817- 6687 F: 813-621-7125
Visit us at www.ussaws.com
sales@ussaws.com
5.10
WARNING:
TO PREVENT SERIOUS INJURY DO NOT OPERATE SAW
WITHOUT PROPER TRAINING.
