(V1.3)
2015 © U-tec Group Inc. All Rights Reserved.
UCG-H2N8E4A2/UCG-H2N8E4B2
Quick Start Guide
Connect the mouse(supplied) to the USB port located at the rear of the H2-N8E.
Congratulations on the purchase of your U-tec CamGuardian. This quick start guide will assist you
on getting your H2-N8E up and running as soon as possible. We recommend that you connect
everything and give it a try before you do a permanent installation, to make sure nothing was
damaged during shipping. Below is a detailed connection map which illustrates the various
connections on the H2-N8E.
G
etting to know your H2-N8E
I
nsert Hard Drive
Back
Step 1: Press button and then the top
cover will spring up.
Hard drive bracket
Step 2: Pull hard drive bracket out.
Step 4: Insert hard drive into H2-N8E,
and replace cover.
Step 3: Fix the hard drive onto bracket as
picture shows.
To connect your camera(s) to the H2-N8E, simply connect the supplied Ethernet cable to the LAN
connection on the camera then plug the other end of the Ethernet cable into one of the camera
inputs on the back of the H2-N8E.
* One H2-N8E supports 8 cameras. 4 cameras can be connected directly. If you want to install 5-8
cameras, these will need to be connected to a router. All CamGuardian cameras support regular or
PoE routers.
To connect your camera(s) to the H2-N8E, simply connect the supplied Ethernet cable to the LAN
connection on the camera then plug the other end of the Ethernet cable into one of the camera
inputs on the back of the H2-N8E.
2
3
6
5
4
C
onnect the Cameras (B2)
C
onnect the Cameras (A2)
C
onnect the Mouse
①
Power Indicator Light: Display power ON/OFF status
②
Status Indicator Light: Display H2-N8E working status
③
Hard Drive 1 Indicator Light: Display hard drive 1 working status
④
Hard Drive 2 Indicator Light: Display hard drive 2 working status
⑤
Power Switch: Switch on/off button
⑥
USB Port: Connect the USB device
1
2
3
5
6
7
4
9
8
①
VGA Port: Connect to a HDTV or Monitor.
②
Network Interface: Network connector port
③
I/O Interface: Alarm input/output and RS485 communication
④
Audio Input: Input audio signal
⑤
Audio Output: Output audio signal
⑥
USB Port: Connect the USB device
⑦
DC48V: Connect to power adapter
⑧
PoE Port: Connect to camera
⑨
HDMI Port: Connect to HDTV or Monitor
Press
A2
Network Cable
B2
Not required
Network Cable
Not required
Front
1
2
1
3
5
2
4
6
