M A N U A L
|
U - T U R N
|
B L A C K L I G H T 2
8 | 9
Winching
Because of its excellent start characteristics and its high trimmed speed, the U-Turn BLACK-
LIGHT 2 offers the best conditions for winching operations. Take the following points into ac-
count:
– do not use a tow line tension over 100 kp with the U-Turn BLACKLIGHT 2.
– If you are not operating at your usual winch, get acquainted with the local procedures. every
visitor on unfamiliar flying grounds needs to get a good briefing by a local pilot.
– never winch the U-Turn BLACKLIGHT 2 with loads outside the permitted weight range.
– All involved persons, machines and accessories need to have the appropriate licenses, ap-
provals or certification for winching. That applies to pilots, hoist operator, towing attachment
& attachment points as well as all further machines and accessories for which a certificate
of competence is required.
Base- and Brakeline adjustment
The factory brake-line setting corresponds to 0-free travel plus 5 cm. The trailing edge needs to
be free and without any pull when the brake lines are completely free and you are in maximum
accelerated flight.
If the brake lines need to be adjusted, attention must be paid that enough free run is possible.
In no case the brakes may be adjusted too short, otherwise the glider may fly with a little, but
continuous applied brake pressure. This could be extremely dangerous during takeoff , flight
and landing!
When fixing the brake handles, always be aware that both sides are adjusted symmetrically and
that a permanent knot is used. The bowline works particularly well because of the fact that it
weakens the line the least but provides excellent slip resistance.
Bowline
①
②
③
Factory
default setting
Summary of Contents for BLACKLIGHT 2
