reV: 16i
SMoGHoG
®
SHM Series Models
12
4.3.3 BASIC SCREENS
Filter Screen:
Figure 7
the filter screen can be displayed by the operator by
selecting the filter status icon on the Home screen shown
in figure 7. the filter screen will then be displayed with
all available filters. this screen will display the differential
pressure across the filter during operation.
Blower Screen:
Figure 8
the standard blower screen will display the status
of the blower. if your equipment is equipped with the auto-
flow option and it is activated, the Blower screen will look
different than that shown in figure 8. refer to section
4.3.4 for additional details. the only time the blower
will shut down is when the blower has an internal fault.
Such faults as: Low line voltage, phase to phase issues,
ground issues, temperature issues, or for a catastrophic
failure. if the blower shuts down, refer to Section 6 for
troubleshooting.
on the blower screen you are able to adjust the speed
of the blower using one of two different methods. the
first adjustment can be done using the up/down arrows.
this adjustment will achieve a change of +/- 1%. this will
increase or decrease the airflow adjustment by 1% for
each touch of the up or down arrows.
the second method of airflow adjustment is to touch the
box that shows the percentage of the airflow. A number
pad will be shown in a pop up screen. you can enter any
number between 20 and 100. this will correspond to the
percentage of blower capability. the blower is capable
of 4,200 rPM at 100%, 3150 rPM for 75%, 2100 rPM
for 50%, and 1050 rPM for 20%. these number are
approximate and may display slightly differently on any
given unit. there is a minimum set point for speed which
is 20% for the purposes of the blower design. the SHM
may have multiple blowers incorporated within the system
to support performance of the unit depending on the
customer application. all of these blowers will respond in
unison with the SHM’s controller.
Information Screen:
Figure 9
the information screen will provide a phone number
for customer service. there is also a web address for
our website that can be used to locate your nearest
representative.
4.3.4 AUTO-FLOW SCREEN
Figure 10
When auto-flow is installed and activated the blower
screen will look like figure 10. refer to section 4.3.6 to
activate the auto-flow option and to make adjustments to
your flow target. the auto-flow blower screen will show
the target flow, the actual flow, the blower speed, and
the % of total speed available. the screen will also show
blower status. if there is a warning or fault, refer to the
troubleshooting section for guidance.
Summary of Contents for SMOGHOG SHM-11C
