WL-3111 User’s Manual
17
Figure 3-14.
Authorized MAC Addresses
The “Load file” button in order to load a file with the MAC Addresses that can be associated with
the Access Point (Authorized MAC Addresses). The “Download” button in order to download the
Authorized MAC Address to the Access Point.
The “Get” button in order to get from the Access Point the Authorized MAC Addresses.
•
Enable SNMP traps -
Using this submenu you can either enable or disable SNMP traps, which
are messages displayed in the right bottom corner of the main window (Figure 3-6) indicating that
an action related to the AP took place. Permitted messages are:
Trap Re-association
: This trap message is sent when a Station’s re-association request is
received from the AP - Bridge.
Trap Association
: Indicates the reception of an association request packet and the sender
Station's successful association with the Wireless Bridge.
Trap Disassociation
: This trap message is sent when a disassociation notification packet is
received from a Station.
Trap Reset
: This trap message is sent when the AP-Bridge resets.
Trap Setting IP Address with Ping
: This trap message is sent when the AP-Bridge IP address
is set with the transmission of a ping message.
Trap Start Up
: This trap message is sent when Bridge starts up.
Trap Failed To Erase Flash
: This trap message is sent when Bridge fails to erase flash.
•
Authorization
- Using this submenu the Administrator can change the password which referred
to the community field (Figure 3-2. Connecting to the UAT -AP using the SNMP Manager) for the
User and the Administrator Authority (Figure 3-15)
