_________________________________________________________________
UAV-1005573-001 Rev D
Page
20
of
46
6.2 skyStation Start-up and Connection
Connect the skyStation to a POE capable network switch. At power-up an
IP address will be assigned to the skyStation by the local DHCP server. By
default, the skyStation will accept TCP connections for User channel
information on TCP port 42430 and the Control channel information on port
42431. An IP Scan can be used to find the IP address of the skyStation.
MAC addresses are printed on the skyStation label.
See section 6.5.3 for configuring the network settings on skyStation.
6.2.1 Run skyLinkApp.exe
In the skyLinkApp.exe, configure the Mode Settings to TCP, enter the IP
address of the skyStation, and enter the default Control port 42431. The
Status box in the upper left-hand corner will turn green indicating a
successful connection to the skyStation.
NOTE: If you are not able to connect to the skyStation it is likely your
firewall is blocking access on port 42431. Please setup your firewall to
allow skyLinkApp.exe TCP access on port 42431.
Please see section 6.5.3 to change or view the network configuration
settings on the skyStation.
See section 6.4 for more details on the
skyLinkApp.
