_________________________________________________________________
UAV-1005573-001 Rev D
Page
28
of
46
6.3.4 Remote Connection to George
The George AutoPilot must be preconfigured to establish a remote
connection. Follow procedures in sections 6.3.1 and 6.3.2 to configure the
AutoPilot.
Verify that the George AutoPilot and skyStation are powered, linked, and
that skyLinkApp.exe is receiving data. Run Mission Planner and select the
communications drop down menu.
Select TCP as the communication mode and hit the Connect button on the
upper right-hand corner.
Enter the skyStation IP address and click OK.
