UAV-1003064-001
Rev G
Page
40 | 50
If not known, use a network scanning software to find the IP address of the
skyStation. The MAC address will be labelled on the bottom of the
skyStation.
When the IP address is known, open a web browser and in the URL search
bar enter the IP address followed by “/update”
Ex: ###.###.#.###/update
Select “Choose File” and select the downloaded skyStation firmware. Then
click “Upload”
DO NOT DISCONNECT THE SKYSTATION OR CLOSE THE
WEBBROWSER UNTIL UPDATE IS COMPLETE
Once file upload is complete click the button that says “Reset MCU”
Once Reset is complete, unplug the skyStation from the POE and plug it
back in to finish the update. Follow steps 1-3 to get reconnected the
skyStation then go to the main IP page by entering the IP address in the
URL search bar.
Ex: ###.###.#.###
Summary of Contents for microLink
