D
End panels position
step 1
Insert Support Pins into the side panels as per the diagram.
step 2
Select Lower Curved End, using the edge of the plastic base as a guide, slide
Curved End horizontally until it joins tightly against side panel.
step 3
Starting with the center hole, using 60mm bolts attach end to base –
finger tighten only.
step 4
Insert left and right bolts (using 55mm bolts), finger tighten only.
step 5
Once all three bolts are in place, check alignment and tighten with allen Key
Please note: Do not over-tighten.
step 6
Select three Connecting Pins and install into top of Lower Curved End as per
diagram using screw driver.
step 7
repeat steps 2–6 on other side.
11
4 x
55mm
bolt
4 x
Support
Pin
6 x
Connector
Pin
2 x
60mm
bolt
