Understanding Default Values and Device Logins
Ubee Interactive
6
Ubee DDW262.G Wireless Cable Modem and Router Subscriber User Guide • September 2011
1.6
Understanding Default Values and Device Logins
This device is pre-configured with the following parameters:
Local Port Address
: 192.168.0.1
Web Interface Address
: http://192.168.0.1
Operation Mode
: Bridge Mode
Subnet Mask
: 255.255.255.0
1.6.1
Using Default Usernames and Passwords
The following usernames and passwords are available at Claro Chile.
Subscriber
Subscribers access the Web interface by opening a Web browser and going to the Web
interface address
http://192.168.0.1
.
The default user name and password is:
User name:
user
Password:
user
1.6.2
Understanding Wireless Defaults
When initially connecting a wireless client to the wireless device, for example, a PC, the
following wireless default values are used:
Important:
The wireless radio is enabled by default.
System Set Identifier (SSID):
The wireless device uses the SSID to advertise
itself. The SSID is equal to “CLARO_” and the last 4 characters of the Cable RF
MAC address. Do not use the MTA MAC address.
Example
:
If MAC Address is:
906EBB42FF34
The SSID is:
CLARO_FF34
Refer to
Finding the MAC Address of the Device on page 7
to find the MAC
address of the device.
Encryption Key:
The device uses 128-bit WEP encryption by default. The
WEP
key
is a 26 digit HEX value. This value is equal to the device MAC address plus
14 zero’s (all lower case without the colons). Example:
906ebb364eae00000000000000 (MAC a 14 Zero’s)
