Ubee DDW262.G Wireless Cable Modem and Router Subscriber User Guide • September 2011
11
2
Installing and Connecting the DDW262.G
Use these instructions to install and connect the DDW262.G.
2.1
Installing the DDW262.G
You install the device by connecting it to a power supply, your computer, and Internet
service.
Subscribers must contact the Internet service provider (ISP) to enable Internet access and
wireless networking.
Typically, the service provider configures and connects the device, however, installation
steps are provided here for your review. If you wish to confirm the setup, or add devices
to your network, refer to
Connecting Devices to Your Network on page 12
.
Steps
To install the DDW262.G:
1. Verify service has been activated on the provisioning system before installing at the
customer premises. Contact your Network Operations Center (NOC) or headend for
instructions if service activation is not completed.
2. Remove the contents from the device packaging. Place the DDW262.G in an optimal
location for connection to other devices, such as PCs or gaming consoles.
Keep the wireless cable modem and wireless clients in open areas or far away
from transformers, heavy-duty motors, microwave ovens, refrigerators, fluorescent
lights, and other manufacturing equipment. These items can impact wireless
signals.
A wireless signal may become weaker after it has passed through metal, concrete,
brick, walls, or floors.
Place the device in a location that has an operating temperature of 0
˚
C to 40
˚
C
(32
˚
F to 104
˚
F). Refer to
Understanding Safety and Regulatory Information on page
1
for more safety regulations.
3. Power on your PC. The PC must have an Ethernet network adapter/Ethernet port and
an Internet browser installed, such as Netscape or Internet Explorer. The following
browsers are supported:
For Windows 2000, XP, Vista, Windows 7: Firefox 1.07 and higher, Internet
Explorer v7 and above, Netscape.
For MAC OS X, 10.2, and higher: Firefox 1.07 and higher, Safari 1.x and higher.
4. Using the power supply included in the product package, connect the power cord to
the
POWER
outlet on the back of the modem and connect the other end into the
power outlet.
