Installing and Connecting the Device
Ubee Interactive
12
Ubee DVW2110 Wireless Voice Cable Modem and Router Subscriber User Guide • December 2011
requests. The default SSID is equal to the last 4 characters of the Cable RF MAC
address printed on the bottom of the cable modem.
For example:
MAC Address =
906EBB360957
SSID =
0957
Note
If you cannot see or connect to the SSID, contact the cable service provider to enable
wireless services.
5. Enter the network key (WEP). This value is found in the Wireless Primary Network
option. To find the default network key:
a. Log in to the device using the MSO login. See
Understanding Default Values and
Device Logins on page 5
.
Note:
If you do not have access to the MSO log in, contact your NOC or headend
for further instructions.
b. Click
Wireless,
and then click the
Primary Network
option.
c. Select an encryption method.
6. Confirm connectivity by opening a Web browser and going to any Web site
(for example,
http://www.wikipedia.org
).
7. Refer to
Troubleshooting the Installation on page 13
for troubleshooting information.
2.2.3
Connecting a Telephone
Voice service requires additional steps for the service provider, including cancelling the
previous telephone provider service, porting the telephone number, and other tasks to
minimize downtime during the transition.
Note
If voice service has not been provisioned through the service provider, telephone
service is not available.
Steps
To connect a telephone:
1. Contact the cable service provider to have voice service enabled.
2. Connect an analog telephone to the TEL 1 or TEL 2 jack on the back panel of device.
An RJ11 cable is supplied in product packaging.
3. Pick up the telephone receiver and listen for dial tone. Make a phone call or have
someone call you.
