background image

Ubee Interactive 

— www.ubeeinteractive.com 

 

 

 

  Ubee DVW325 

– Safety and Installation Product Insert v1.0 

 

The device must carry a label stating “FCC 
ID: XCNDVW325.” 

FCC Caution: Any changes or modifications not 
expressly approved by the party responsible for 
compliance could void the user's authority to 
operate this device. 

IEEE 802.11b or 802.11g operation of this device 
in the U.S.A. is firmware-limited to channels 1 
through 11. 

For operation within 5.15 ~ 5.25GHz frequency 
range, it is restricted to indoor environment. This 
device meets all the other requirements specified 
in Part 15E, Section 15.407 of the FCC Rules 

 

FCC Radiation Exposure Statement:

 

This device complies with FCC radiation 
exposure limits set forth for an uncontrolled 
environment. This device should be installed and 
operated at a minimum distance of 20cm 
between itself and your body. 

This device must not be co-located or operating 
in conjunction with any other antenna or 
transmitter. 

 

Safety Notices   

Read these instructions carefully before 
operating the device. It is important to be aware 
of these safety instructions. Install the device 
according to these instructions and keep this 
guide for future reference. 

1. 

Do not use this device in a humid 
space, in the rain, or near splashing 
water. 

2. 

Do not install during thunder or 
lightening storms. 

3. 

Do not cover any ventilation openings 
in the device case. 

4. 

Do not place the device near heat 
sources such as radiators or stoves. 

5. 

Clean the device only with a clean, 
dry cloth. Do not use liquid or 

Summary of Contents for DVW325








Reviews: