Ubee Interactive
Understanding Default Values and Logins
Ubee DVW326 Advanced Wireless Voice Gateway Subscriber User Guide • March 2014
9
DTMF Tone Detection, T.38 FAX Relay (G.711), Echo Cancellation (G.168) /
Silence Suppression, Voice Active Detection and Comfort Noise Generation
G.722 codec, WB SLIC
Device Management
Supports IEEE 802.11e Wi-Fi Multimedia (WMM) and UAPSD (power savings)
DOCSIS, Web-Based, and XML Configuration
Telnet/SSH remote management
Firmware upgrade via TFTP
Configuration backup and restore
SNMP support
TR-069 capable
Physical and Environmental
Dimensions: 63.4mm, 2.4” (W) x 233mm, 9.125” (H) x 225mm, 8.8” (D)
Weight: 923g (2 lbs.) (Contains internal PSU)
Input: 100-120VAC, 50-60Hz
Output: 12V 2.17A
Operating Temperature: 0°C ~ 40°C (32°F ~ 104°F)
Humidity: 5~90% (non-condensing)
1.7
Understanding Default Values and Logins
The DVW326 is pre-configured with the default parameters for Cox Communications.
Some regions may change default values using the cable modem or XML configuration
file. Check with your provisioning team to determine the default values for your region.
Local Port Address: 192.168.100.1
Web Interface: http://192.168.100.1
Operation Mode: NAT Mode
Subnet Mask: 255.255.255.0
Wireless Defaults:
Primary SSID (subscriber-managed) = “DVW326” plus a period, plus the last 6
characters of the Wi-Fi MAC address plus “-2.4G”.
Example for modem with WLAN MAC address F4:B7:E2:E5:C6:1A
SSID: DVW326.E5C61A-2.4G
If the subscriber changes the SSID, the device does not revert to this default
SSID when the device is reset, except when a manual factory reset is
performed through the Web UI.
The Wi-Fi MAC address can be found at the top of the Wireless Primary
Network screen. Refer to
Using the Primary Network Option on page 71
.
Encryption Method = WPA2-PSK with TKIP+AES encryption
