Ubee Interactive
Using the Wireless Radio Option
Ubee DVW326 Advanced Wireless Voice Gateway Subscriber User Guide • March 2014
70
9.1.1
Scanning for Wireless Access Points (APs)
You can search for wireless access points and display the results in a new window.
Steps
To search for wireless access points:
1. Click
Scan Wireless APs
at the bottom of the Wireless Radio screen. Results are
displayed in a new window.
2. Click
Refresh
to update the results. Field descriptions are provided below.
Bandwidth
Sets the bandwidth to 20Mhz or 40Mhz. For 40 MHz, set the
sideband to lower or upper 20Mhz. 40 MHz channels double
the channel width. This allows doubling the PHY data rate
over a single 20 MHz channel.
Sideband for Control Channel
(40MHz only)
Only when using 40MHz Bandwidth should you choose the
Lower or Upper 20MHz.
Control Channel
Set to Auto by default, the Control Channel selects a specific
channel to deploy the wireless network. This allows you to set
the operating frequency/channel depending on your particular
region. Channel selection can have an impact on wireless
networking performance. For more information, refer to
Selecting a Wireless Channel on page 87
Regulatory Mode
Defines whether Regulatory Mode is set to off, 802.11d, or
802.11h.
TPC Mitigation (dB)
Defines the transmitter power control (TPC) mitigation setting
as 0 (off), 2,3, or 4.
OBSS Coexistence
Enables or disables overlapping BSS coexistence.
STBC Tx
Sets the space-time block codes (STBCs) for the transmitting
antenna.
Apply
Saves all screen changes when clicked.
Restore Wireless Defaults
Restores the factory default settings for wireless
configurations when clicked.
Scan Wireless APs
Scans for other wireless access points and displays channel,
encryption, SSID, RSSI levels, and other information. See the
section below for more information.
Label
Description