Ubee Interactive
Connecting Devices to the Network
Ubee DVW32CB Advanced Wireless Voice Gateway Subscriber User Guide • January 2015
14
Steps
To mount the DVW32CB on a wall:
1. Install the two screws horizontally on a wall 5.75 inches (148mm) apart. See the figure
below.
The screws should protrude from the wall so that you can fit the device between the
head of the screw and the wall. If you install the screws in drywall, use hollow wall
anchors to ensure the unit does not pull away from the wall due to prolonged strain
from the cable and power connectors.
2. Mount the device on the wall.
2.2
Connecting Devices to the Network
Use the instructions below to connect network devices and validate device functionality.
Topics
See the following topics:
Connecting an Ethernet Device on page 14
Connecting a Wireless Device on page 15
Connecting a Telephone Line on page 16
2.2.1
Connecting an Ethernet Device
You can connect up to three additional Ethernet devices to the DVW32CB.
Steps
To connect another Ethernet device to the network:
1. Connect an Ethernet cable from the Ethernet device (for example, a PC or gaming
console) to an open Ethernet port on the back of the DVW32CB.
2. Use the device LEDs to confirm operations. Refer to
Understanding LED Behavior on
page 6
for more information.
3. Open a Web browser and go to any Web site to validate network/Internet connectivity
(for example,
http://www.wikipedia.org
).
4. If the connected device is a gaming console, perform any online task supported by the
