Ubee Interactive
Using the LAN Option
Ubee UBC1301-AA00 Advanced Wireless Voice Gateway Subscriber User Guide • March 2017
39
6.2.2
Using the DHCPv6 Option
Use the
DHCPv6
option to configure
IPv6 host IP addresses, IPv6 prefixes, and various
configuration data required to operate in an IPv6 network.
To configure DHCPv6 settings:
1. Click
LAN
from the left side menu.
Lease Time
Defines the DHCP lease time duration in minutes between 1 and 71582788. A DHCP user's
PC gets an IP address with a lease time. When the lease time expires, the PC must
connect to the DHCP server and be issued a new unused IP address.
Note:
The default DHCP lease time is 3600 seconds and should be changed to
86400
seconds (24 hours). This helps resolve connectivity issues with some printers, iMAC and
Windows 7 devices that turn off the network interface when they go into standby mode.
This results in slow Web browsing until the device gets a new IP address via DHCP.
Add Entries
Click the
Add Entries
button to add DHCP IPv4 Address Lease Reservations. The
following pop-up window appears. Enter the MAC and IP addresses, then click
Apply
.
After clicking Apply, the lease reservation appears in the table as shown below.
To remove a DHCP IP lease, click the
Delete
button next to the entry in the table.
Enable DHCP Server
Relay
Check the box to enable a host that forwards DHCP packets between clients and servers.
DHCP Server IP
Address
Allows you to enter the IP Address for the DHCP Server Relay host.
MTU Size
Allows you to enter the maximum transmission unit (MTU) size. MTU defines the largest
size of the packet or frame that the device can transfer (256-1500). If this is not given by
your service provider, use 0 for the default.
Apply/Save
Saves all changes.
Label
Description
