Ubee UBC1329AA00 Advanced Wi-Fi 6 Voice Gateway User Manual • February 2021
6
1.5
Device Connections
The following table describes the connections on the rear panel of the
UBC1329AA00.
1.6
LED Behavior
The following tables summarize the behavior of the LEDs on both the front and
rear panels of the UBC1329AA00.
Label
Description
RESET
To reset (power cycle) the device, use a pointed object like the end of a paper clip to push
down the reset button. To power cycle the device, hold for
less than 5 seconds
. To reset to
factory default settings, hold for
more than 5 seconds
. The UBC1329AA00 will reset and
reboot.
WARNING:
Resetting to factory defaults will erase any and all settings you have
configured and will restore to factory default settings.
ETHERNET
1-4
Connects to Ethernet devices such as computers, gaming consoles, and/or routers/hubs
using an RJ45 cable. Each Ethernet port on the back panel of the device has an LED to
indicate its status when an Ethernet-enabled device is connected.
CABLE
Connects to the cable outlet (with the cable provided by your service provider), or a cable
splitter connected to the cable outlet.
TEL1
TEL2
Connects to standard telephones using an RJ11 cable. Telephone service must be enabled
by your service provider.
PWR
(POWER)
Connects the power cable to the device. Use only the power cable provided with the
UBC1329AA00.
BATT
(BATTERY)
Connects to an
OPTIONAL
external battery backup unit. The battery is not included in the
product packaging. Subscribers must contact the service provider to obtain a battery.
Battery supports continuous voice service during power outages, and provides up to 24
hours standby time, and 5 hours talk time with one line active. Actual performance is
affected by battery age and operating environment.
FRONT PANEL
LED
Color
Description
POWER
GREEN
On –
Internal power-on completed successfully.
Flashing –
Power-on failed.
NOTE:
The LED blinks briefly immediately after
powering on the device.
Off –
No power supplied to the device.
