10
3. Side burner Assembly
1. Assemble the brass connector into side burner by hand, then tighten with a wrench. Make sure it is
secure; do not over-tighten. See the Fig.5
2. Connect the ignition wire from the hole of the right side panel, then through the burner fixed bracket
(DD) inserted into the side burner igniter pin. See the Fig.5-1
Note:
After completing the side burner installation, tighten the brass connector with a wrench.
4. Position flame tamers and cooking grids and warming rack
a) Flame tamers are packed in the main firebox assembly. Please make sure the flame tamers are
centered over the burners. See fig Fig.6
b) The cooking grids and warming rack are also packed inside in the firebox assembly. Place the cooking
grids and warning rack in the firebox assembly before using your grill. See below.
Fig. 5
Fig. 5-1
Fig. 5
Fig. 6
Fig. 6
DD
Summary of Contents for 780-0384
Page 23: ...23 Exploded View D D D ...
Page 46: ...46 Vue éclatée D D D ...