Uberhaus MPN2-12ERN1-BH2, User Manual

CARE AND MAINTENANCE

CARE AND MAINTENANCE

     1)  Be sure to unplug the unit before cleaning or servicing.
     2)  Do not use gasoline, thinner or other chemicals to clean 
          the unit.
     3)  Do not wash the unit directly under a tap or using a  hose.
          It may cause electrical danger.
     4)  If the power cord is damaged, it should be repaired by 
          the manufacturer or its agent.

IMPORTANT:

1.   Air filter

-     Clean the air filter at least once every two weeks to prevent 
      dust from impacting fan operation. 
-     Removal 
      This unit has two filters. Take the upper filter out along the
      the arrow direction (Fig.26),then takel the filter down. 
      Remove the lower filter by loosening the screw, taking down 
      the air filter as shown in Fig.27 and Fig.28.    
-     Cleaning 
      Wash the air filter by immersing it gently in warm water

O

O

      (about 40 C/104 F) with a neutral detergent. Rinse the filter 
      and dry it in a shady place. 
-     Mounting 
      Install the upper air filter after cleaning and install the lower 
      filter by using the screw.

2.   Unit enclosure

-     Use a lint-free cloth soaked with neutral detergent to clean 
      the unit enclosure. Finish with a dry clean cloth.

Fig.26

3.   If the unit has been idle for a long time

Air filter
(take out)
 

-     Remove the rubber plug at the back of the unit and attach
      a hose to drain outlet

. Place the open end of the hose 

      directly over the drain area in your basement floor

      (See Fig.23 & 24).
-     Remove  the plug from the bottom drain outlet, all the water 
       in the bottom tray  would drain out (See Fig.25). 
-     Keep the appliance running on FAN mode for half a day in 
      a warm room to dry the appliance inside and prevent mold.
-     Stop the appliance and unplug it, wrapped the cord and 
      bundle it with the tape. Remove the batteries from the 
      remote controller.
-     Clean  the air filter and reinstall it.
-     Disconnect the exhaust hose, keep it safety, and cover the 
      window (wall) hole with the adaptor cap.

Fig.27

Remove the 
screws and 
take the air
filter down 

NOTE: 

The grill and the air filer are connected and cannot be

             separated..

Fig.28

Remove the 
screws and 
take the air
filter down 

Model A

Model B

 13