32
UBI EasyCoder 501 – Technical Manual
SETTING UP EASYCODER 501
Different Methods
The EasyCoder 501 is intended for applications, where the printing
will be controlled from a host computer and very little action is
required by the operator. Accordingly, there is only one key
available on the membrane keyboard on this type of printer.
The use of optional serial interface boards have been excluded from
this model. The same applies to the choice of performance level.
The method of changing the setup depends on whether the printer
is fitted with some kind of startup file, a subject that was more
thoroughly discussed in the chapter Starting Up earlier in this
manual, to which the alphabetic references below refer.
A. EasyCoder 501 with EasyPak Startup:
There is no Setup Mode in the EasyPak Startup program, but
some setup parameters can be changed from within UBI LabelShop,
and – for the UBI Windows Driver – from “Control Panel/
Printers” in Microsoft Windows.
B. EasyCoder 501 with UBI Shell:
• You can change any setup parameter via the Terminal Setup
option in UBI Shell Standard.
• You can change the LSS setup via the Setup option of UBI Shell.
• As an alternative, you can also change the setup by means of a
setup file or setup string, see
SETUP
in the UBI Fingerprint
Reference Manual or in the UBI Direct Protocol Programmer's
Guide.
D. EasyCoder 501 with no startup file installed:
• An EasyCoder 501 without any startup file can only be set up by
means of setup files or setup strings, see
SETUP
in the UBI
Fingerprint Reference Manual or in the UBI Direct Protocol
Programmer's Guide.
E. EasyCoder 501 with a custom-made application program:
• Normally, necessary provisions for changing the setup should be
provided by the program by means of setup files or setup strings,
see
SETUP
in the UBI Fingerprint Reference Manual or in the UBI
Direct Protocol Programmer's Guide.
