56
UBI EasyCoder 501 – Technical Manual
Roll Size
PAPER DIMENSIONS
Bobbin (Ø 38 mm/1.5")
Note:
175
µ
m is the recommended maximum
thickness. Thicker web may be used at
the possible expense of an impaired
printout quality. However, the stiffness
is also important. A stiff web limits the
maximum thickness and vice versa.
Adapter (Ø 76 mm/3")
Restrictions applying to paper rolls fitted inside the printer:
Core:
Diameter w/o adapter .. :
38–40 mm
(1.5–1.6")
Diameter w. adapter .... :
76 mm
(3")
Width ......................... : Must not protrude outside the web.
Warning!
The web must not be attached the core in such a manner
that the printer cannot pull the end of the web free from the
core. Else, the thermal transfer ribbon may be damaged.
Roll:
Max. diameter ............. :
205 mm
(8.07")
Max. width ................. :
120 mm
(4.72")
Min. width .................. :
25.4 mm
(1.0")
Max. web thickness ..... :
175
µ
m
(0.007")
see note!
We recommend that a paper roll fitted inside the printer should be
wound with the labels, printable surface or thermal coating facing
outwards.
For paper supply outside the printer, e.g. fan-folds or external paper
roll, the only restriction to be observed is the width and thickness of
the web, which should be the same as for an internal paper roll.
Important! Any external paper supply should be well protected
against sand, grit etc. Even very small but hard foreign particles
may cause severe harm to the delicate printhead.
Web width:
Max. 120.0 mm ( 4.7")
Min. 25.4 mm (1.0")
Printable
side
or
labels
Core diameter:
38 - 40 mm (1.5" - 1.6")
or
76.2 mm (3")
Roll diameter:
max. 205 mm (8")
