63
UBI EasyCoder 501 – Technical Manual
❑
Turn off the power to the printer and open the front lid.
❑
In case of non DOS-formatted memory card, check that the
protection switch is set to Write Protect. (The location of the
switch varies between different brands). This does not apply to
DOS-formatted memory cards!
❑
Insert the memory card into its adapter as illustrated below.
Make sure that the manufacturer's logotype on the memory card
is facing upwards.
❑
Press firmly inwards so the pins in the adapter engage the
corresponding slots in the memory card.
❑
Turn on the power again and close the front lid.
❑
Before removing the memory card, turn off the power.
❑
Open the front lid and pull the card straight out.
❑
Close the front lid and turn on the power again.
MEMORY CARD ADAPTER, cont'd.
IMPORTANT!
The printer must be OFF when
the memory card is inserted or
removed.
Fitting a Memory Card
Protection Switch
Removing a Memory Card
MEMORY CARD
Memory Card
