background image

 



FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE 
STATEMENT

 

 

 

This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures: 
-Reorient or relocate the receiving antenna. 
-Increase the separation between the equipment and receiver. 
-Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected. 
-Consult the dealer or an experienced radio/ TV technician for help. 

 

CAUTION:

 

Any changes or modifications not expressly approved by the grantee of this device 

could void the user's authority to operate the equipment. 

 

Labeling

 

requirements

 

 

This

 

device

 

complies

 

with

 

Part

 

15

 

of

 

the

 

FCC

 

Rules.

 

Operation

 

is

 

subject

 

to

 

the

 

following

 

two

 

conditions:

 

(1)

 

this

 

device

 

may

 

not

 

cause

 

harmful

 

interference,

 

and

 

(2)

 

this

 

device

 

must

 

accept

 

any

 

interference

 

received, including interference that may 

cause undesired operation. 

 

RF

 

exposure

 

warning

  

 

 

This equipment must be installed and operated in accordance with provided 

instructions and must not be co-located or operating in conjunction with any 

other antenna or transmitter. End-users and installers must be providing with 

antenna installation instructions and transmitter operating conditions for 

satisfying RF exposure compliance. 

SAR Value: 1.450 W/kg 

This

 

device

 

is

 

operation

 

in

 

5.15

 

 

5.25GHz

 

frequency

 

range,

 

then

 

restricted

 

in

 

indoor

 

use

 

only,

 

Outdoor

 

operations

 

in

 

the

 

5150~5250MHz

 

is

 

prohibit.

 

 

This

 

device

 

is

 

slave

 

equipment,

 

the

 

device

 

is

 

not

 

radar

 

detection

 

and

 

not

 

ad

hoc

 

operation

 

in

 

the

 

DFS

 

band.

 

 

 

Summary of Contents for T10CA10










Reviews: