Hardware Installation
Important:
Handle the Dish Reflector with care.
Deformations in its shape may reduce the RocketDish's
effectiveness.
1. Each M4 Bolt includes a lock washer. Remove these and use
them to secure the bolts when assembling.
2. The Dish Reflector and Antenna Feed are keyed so the
Antenna Feed can only be installed in a single orientation.
Attach the Antenna Feed to the Dish Reflector in the
following steps:
a. Line up the alignment pin on the Dish Reflector with the
hole on the Antenna Feed.
b. Insert the four M4 Bolts into the Antenna Feed and Dish
Reflector.
c. Tighten the four M4 Bolts.
Important:
Do not handle the RocketDish by the Antenna
Feed once the feed is connected.