8
Chapter 2: Installation
UniFi
™
AP-PRO and AP-AC User Guide
Ubiquiti Networks, Inc.
Hardware Installation of the UniFi
AP-AC
The UniFi AP-AC can be mounted to the wall or ceiling.
Perform the steps for the appropriate installation:
Wall Mount
1. Position the
Mounting Bracket
at the desired location
on the wall with the cable feed slot pointed towards
the floor.
2. Use a pencil to mark the four mounting holes. Use a 6
mm drill bit to drill the mounting holes.
Top
Optional 25 mm Hole for
Ethernet Cable Feed through Wall
3. Follow the instruction for your type of Ethernet cable
feed:
-
Feeds Through the Wall
Cut or drill a circle
approximately 25 mm in diameter, just below the
bottom center of the
Mounting Bracket
(as shown
above). Then feed the CAT5/6 cable through the hole.
-
Feeds Along the Mounting Surface
Remove the
Cable Feed Plug
on the side of the UniFi AP.
4. Insert the
M3x20 Screw Anchors
into the 6 mm holes.
Secure the
Mounting Bracket
to the wall by inserting
the
M2.9x20 Screws
into the anchors.
5. Connect the Ethernet cable to the
Main
port. If the feed
is along the mounting surface, feed the cable through
the
Cable Feed
of the UniFi AP.
MAIN
SECONDARY
RESET
This device complies with Part 15 of FCC rules.
Operation is subject to the following 2 conditions:
1) this device may not cause harmful interference
and, 2) this device must accept any inter ference
received, including inter ference that may cause
undesired operation.
FCC ID: SWX-UAPAC I C : 6 5 4 5 A - U A P A C
0560
M / N: U A P-AC 48V 0.5A POE
A P
A C
|
6. Align the slots on the UniFi AP with the tabs on the
Mounting Bracket
.
7. Slide the UniFi AP down until it locks into place.
