3
Ubiquiti Networks, Inc.
Chapter 2: Installation
UniFi Enterprise WiFi System User Guide
Chapter 2:
Installation
Hardware Installation
The UniFi Enterprise AP is powered by the included PoE
(Power over Ethernet) adapter. To install the AP, perform
the following steps:
1. Connect an Ethernet cable to the Ethernet port on the
UniFi Enterprise AP.
2. Connect the power cord to the power port on the PoE
Adapter. Connect the other end to of the power cord to
a power outlet.
3. Connect the other end of the Ethernet cable to the
Ethernet port labeled POE on the PoE Adapter.
Note:
If you plan to mount the AP on your ceiling,
perform the ceiling mount installation steps before
connecting the Ethernet cable to the PoE Adapter.
Below is an overview of the Power over Ethernet
connections.
Power Connection Diagram
Mounting the Access Point
The UniFi Enterprise AP can be wall-mounted or
mounted on a ceiling. Perform the following steps for the
appropriate installation:
Wall-Mount
1. Align the wall-mounting bracket with the Wall Mount
text facing up. There are horizontal and vertical lines on
the bracket to help with orientation.
Wall Mount
Wall Mount text
2. Use a pencil to mark the holes on the wall.
3. Use a 6 mm drill bit to drill the holes in the wall.
4. Insert the 3 screw anchors into the wall.
5. Secure the wall-mount bracket to the wall by inserting
the self tapping screws into the anchors.
Wall Mount
Summary of Contents for UniFi
Page 1: ...Enterprise WiFi System...
