Ubisense
– Ultra-wideband Location System – UBISENSOR30V1 Revision D
Calibrating the UBISENSOR30V1
When the UBISENSOR30V1 has been installed in its final location, its position and orientation
must be found and entered into the Ubisense location system’s dataset. The Ubisense
location system management tools make this calibration process simple and quick
– refer to
Troubleshooting
If you believe that the UBISENSOR30V1 is not functioning correctly, and the Ubisense
location system management tools are not able to diagnose the problem, it is likely that the
unit is not communicating with the rest of the location system for some reason. Check the
following:
•
The networking cable is fully plugged in at both ends.
•
The unit is connected to a network connection which is providing PoE power.
•
Your local network port is connected to the rest of your network.
•
The link light corresponding to the device
’s network connection is illuminated on the
nearest upstream switch.
If you are still unable to determine the cause of the problem, contact your system installer or
Ubisense.
