EVK-JODY-W3 - User guide
UBX-20030840 - R02
Getting started
Page 11 of 29
Bluetooth, communication with the JODY-W3 series module.
Figure 3: SDIO connector
o
A high speed UART interface can be used for Bluetooth communication with the JODY-W3
series module. A USB-to-UART bridge is included on the evaluation board. To use the Bluetooth
interface through USB, connect the included USB cable to the USB type-C connector on the
EVK (see Figure 2) and connect it to a USB interface on the host system. Make sure that
jumper J400 is bridged (default setting) to enable Bluetooth communication over USB. Refer
to section 4.6 for information how to access the UART interface for Bluetooth directly.
5.
Power on the host system. The LEDs on the EVK for the different voltage levels should turn green
to indicate proper power supply. At this point the module should be detected by the host system.
6.
Install the necessary driver software for the JODY-W3 series module as described in the System
integration manual [2].
