UBTECH AIMBOT
USER MANUAL
UBTECH ROBOTICS CORP LTD
Remove the object or paper to ensure that the place or object that needs to be disinfected
can be exposed to ultraviolet light Under the light. If the home in the room moves, you need
to move ADIBOT for a round of disinfecting.
Step 3
The operator leaves the room and closes the door to prevent anyone from
entering the disinfecting site. Place the warning sign at the door and turn on it.
Set and start the disinfecting task on the Web terminal;
Plug the ADIBOT into the power source and press the switch on the back of the device
base to start the device. After leaving the disinfecting site, the operator accesses the
designated IP address to log in to the control software of the device through the mobile
phone, sets various parameters on the software and executes the disinfecting task.
Note: When the device is turned on, the infrared human detection sensor will stabilize
after 30 seconds. After setting the disinfect time, start the disinfect task (or set or start via
the remote control). After the task is started, there is a 20-second countdown to remind the
operator to leave the disinfecting site. When the time is up, the UV lamp will be lit and the
disinfecting will start.
Important: The operator must leave the disinfecting site before the end of the
countdown to avoid being exposed to UVC lights.
Step 4
After the disinfecting is over, enter the room to push away the equipment and
close the access card.
After the disinfecting task is completed, the phone screen will display "Completed".
The operator can enter the room and move the equipment to other locations to be
disinfected. If the task is terminated because the sensor detects an abnormality, the task
needs to be restarted after the end of the task.
Part 4 Web and Remote Controller
Operation
4.1 Web Software Features
No.
Feature
Decription
1
System
Settings
Internet Settings
Choose network mode or hotspot mode.
Specify the Wi-Fi router SSID, password, server IP,
and port. Switch to the network mode to access
the central network.
2
User Login
Login
Default User:
“admin”
D
efault passwords:
“123456”
3
Task
Management
Disinfection
Mode Settings
Choose disinfection onsite
4
Report Management
View, download reports, review videos
