![background image](http://html1.mh-extra.com/html/uchida/aerocut-x/aerocut-x_service-manual_3170113109.webp)
AeroCut X / XPro SERVICE MANUAL
109
7
This occurs when Slitter Unit is
overloaded.
If this occurs frequently,
·
Paper tip could remain inside of the machine.
·
Slitter Movement Screws or shaft may be out
of order.
·
Tension of Timing Belt may need to be
adjusted.
·
Screws of Timing Pulley need to be checked
for their tightness.
·
Sensor (SLTR1-4 HM POS) may be out of
order.
(
Page19
·
Origin Sensor’s location may be set
incorrectly.
·
Slitter Motor may be out of order.
·
I/O Board may be out of order.
·
CPU Board may be out of order.
·
Wire breakage or connection failure may
have occurred.
8
This occurs when Cut Mark
could not be detected.
·
Cut Mark printing density needs to be
checked.
·
Cut Mark Sensor needs to be re-
adjusted.
(
Page54
·
Cut Mark Sensor may be out of order.
·
CPU Board may be out of order.
·
Wire breakage or connection failure may
have occurred.
9
Two or more sheets are fed at
one time.
If this occurs frequently,
·
Fan out the paper sufficiently and jog the
paper to make the each of the sheets
separately.
·
Adjust the volume of Blower FAN and
Vacuum Fan.
·
Blow motor may be out of order.
Note:
Activate double-feed detection mode.
☞
OPERATION MANUAL
「
5.1 Adjustments on the paper feed section
」
10
This occurs when a servo error
is detected.
·
COVER SENS A, B may be out of order.
(
Page19
·
Servo Motor Driver may be out of order.
·
Servo Motor may be out of order.
·
CPU Board may be out of order.
·
Wire breakage or connection failure may
have occurred.
Summary of Contents for AeroCut X
