AeroCut X / XPro SERVICE MANUAL
112
19
The dimensions of finished card
are different from the
measurements you have input.
·
Make it correct at ADJUST Screen.
☞
OPERATION MANUAL
AeroCut XPro
「
5.6.2 If the cut measurement does not
match the input value
」
AeroCut X
「
5.5.2 If the cut measurement does not
match the input value
」
20
The lengths of finished cards
are unequal.
·
Clean Carrying rollers.
·
Clean Sensors.
·
Cutter blades could have got damaged
and got partly dull. Replace the cutter
unit.
21
The widths of finished cards are
unequal.
·
Clean Carrying rollers.
·
Slitter blade could have got damaged and
got partly dull.
·
CPU Board may be out of order.
·
Servo Motor Driver may be out of order.
·
Servo Motor may be out of order.
22
Two or more sheets are fed at
one time.
If this occurs frequently,
·
Fan out the paper sufficiently and jog the
paper to make the each of the sheets
separately.
·
Adjust the volume of Blower FAN and
Vacuum FAN.
·
Blow motor may be out of order.
Note:
Activate double-feed detection mode.
23
A sheet stops after moving
slightly
(
with noise
)
·
Thick paper cannot be fed at higher
speed and a sheet stop being fed with
noise.
Please slow down the speed.
24
Paper jam occurs frequently.
·
Paper curl too much to be conveyed
smoothly.
·
The dimensions of the paper are different
from the measurements you input into the
machine.
·
Paper tip could remain inside of the
machine.
(Origin sensor, Slitter, Cutter, Creaser,
Perforator)
25
Paper remains at a Crease
blade.
·
Make Crease depth smaller.
☞
OPERATION MANUAL
AeroCut XPro
「
5.5 Creaser adjustment
」
AeroCut X
「
5.4 Creaser adjustment
」
26
The movement of slitter block is
not smooth.
Please adjust slitter head.
(
Page35
27
It sounds strange while slitter
block is moving.
Please adjust slitter head.
(
Page35
Summary of Contents for AeroCut X
