AeroCut X / XPro SERVICE MANUAL
16
AeroCut X
①
SV OFF: the state where the servo motor does not respond to any orders.
SV ON: the state where the servo motor responds to all orders.
②
Carrying roller will rotate.
③
Carrying roller will rotate. (Continuous)
④
The speed of Carrying roller can be adjusted to two levels (SLOW or FAST).
⑤
Adjustable the carrying speed.
⑥
Carrying rollers will rotate at input length. [mm]
⑦
Enter the dimension of Fixed feed.
⑧
Counter for servo movement.
⑨
Reset the counter for servo movement to zero.
⑩
Guillotine will move once.
⑪
Crease will move upper limit.
⑫
Crease will move lower limit.
⑬
FEED TABLE will move upward while this is being pressed.
⑭
FEED TABLE will move downward while this is being pressed.
⑮
Go to SLITTER Operation Screen.
⑯
Stop all operations. Of note, Cutter and Crease will move to the upper limit.
⑰
<<
:
Feed belt will rotate positively by pressing this once.
It will stop by pressing it again.
>>
:
Feed belt will rotate negatively by pressing this once.
It will stop by pressing it again.
⑱
Vacuum motor will be turned ON and OFF.
⑲
Adjustable the Vacuum pressure.
⑳
Blow motor will be turned ON and OFF.
㉑
Adjustable the Front Blower pressure.
㉒
Adjustable the Side Blower pressure.
㉓
Go to INPUT DATA CHECK screen.
㉔
Double Feed Detection
Summary of Contents for AeroCut X
