![background image](http://html1.mh-extra.com/html/uchida/aerocut-x/aerocut-x_service-manual_3170113035.webp)
AeroCut X / XPro SERVICE MANUAL
35
Note.
Movement of slitter head is not good.
…
Especially when a slitter movement is heavy.
①
Please operate slitter head to find the position where the movement is
heavy.
②
Please stop slitter head and loosen “cross recessed head screws”, then
tighten it again.
Note.
It sounds strange while a slitter unit is moving.
…
Especially when it sounds strange.
①
Please operate slitter head to find
the position where it sounds strange.
②
Please stop slitter head and loosen
“Bolts”, then tighten it again.
·
When “Bolts” is tighten, please
be careful not to make any space
between “Slitter moving nut” and
“Bracket”.
·
This space may happen “slitter
rattle” so that it could make
inaccurate cutting by slitter unit.
③
For more smooth movement of slitter
unit, please put some of silicone oil
on screw shaft.
·
When it is done, please be
careful not to put silicone oil on
carrying roller.
·
Oil on carrying roller might cause
inaccurate cutting result.
Cross recessed
head screws
Bracket
Slitter
moving nut
Screw
shaft
Bolts
Summary of Contents for AeroCut X
