AeroCut X / XPro SERVICE MANUAL
14
3.2
MANUAL OPERATION Screen
AeroCut XPro
①
Carrying roller will rotate.
②
Carrying roller will rotate. (Continuous)
③
The speed of Carrying roller can be adjusted to two levels (SLOW or FAST).
④
Carrying rollers will rotate at input length. [mm]
⑤
Enter the dimension of Fixed feed.
⑥
X-Perfo blade will move toward far side from an operator.
⑦
X-Perfo blade will move toward near side from an operator.
⑧
X-Perfo blade will move to specified point .[mm]
⑨
Input moving distance of X-Perfo blade.[mm]
⑩
Guillotine will move once.
⑪
Crease will move upper limit.
⑫
Crease will move lower limit.
⑬
X-Perfo blade will move to initial position.
⑭
FEED TABLE will move upward while this is being pressed.
⑮
FEED TABLE will move downward while this is being pressed.
⑯
Go to SLITTER Operation Screen.
⑰
Go to INPUT DATA CHECK screen.
⑱
SV OFF: the state where the servo motor does not respond to any orders.
SV ON: the state where the servo motor responds to all orders.
⑲
Go to SPEED screen.
⑳
Vacuum motor will be turned ON and OFF.
㉑
Blow motor will be turned ON and OFF.
㉒
Counter for servo movement.
Summary of Contents for AeroCut X
