AeroCut X / XPro SERVICE MANUAL
43
6.1.2
Accuracy adjustment
①
AeroCut XPro
Regarding Length adjustment, refer to “5.6.2 If the cut measurement does
not match the input value” in Operation Manual.
AeroCut X
Regarding Length adjustment, refer to “5.5.2 If the cut measurement does
not match the input value” in Operation Manual.
②
Overwrite the initial setting value when you finished adjustment.
AeroCut XPro
Double click the bottom left corner.
Enter the service password.
AeroCut X
Click the top right corner 5 times.
Enter the service password.
③
The values shown on the screen will be 0 after overwriting.
The ×1.000 (length magnification) part will not become ×1.000 by double-
clicking the top-right corner (will not be stored internally).
④
If you prefer to reset values to factory settings, amend values shown on the
Service Menu screen according to data which is attached inside of the front
cover.
(
Summary of Contents for AeroCut X
