94 | SWIFT K33A ALL IN ONE FUSION SPLICER
americanilsintech.com | 95
How to indicate cleave angle, optical fi ber’s angle and core/clad deviation.
Refer to [Option menu].
Difference between estimated splice loss and measured splice loss.
The estimated splice loss is just a result from a statistical calculation and to be used for
reference only.
SLEEVE HEATER
The sleeve heater does not suffi ciently shrink the protection sleeve
Increase the duration of heating time. Refer to [Heat Menu] for more information.
The sleeve heater is overheated.
Stop the operation of the heater by pressing . Turn off the power and contact
UCLSWIFT Co., Ltd.
When the sleeve is not separated from the heating plate, use a cotton swab or a similar
object to this to push or remove the sleeve.
How to initialize the heating condition in the heat mode.
Refer to [Heat Menu] for more information.
How to cancel the heating process.
You cannot cancel the heating process by pressing . Press one more time to
cancel it.
MISCELLANEOUS CONDITIONS
How to lock “Splice”, “Edit” or heat mode.
Refer to Lock Menu for more detailed information.
Arc amount is not changed after performing [Arc Calibration].
The internal standard discharge amount is calibrated. Therefore, discharge amount of
each splice mode does not change.
If you forget the password.
Contact UCLSWIFT Co., Ltd.
TRANSPORTING YOUR K33A
The Swift K33A is high precision equipment and is required to be transported it in a safe
case to protect it from humidity, vibration and physical shock. In the case of repair, it must
be shipped in the protective case along with its parts during its transport.
REPAIR
Any data saved in the memory including splice results and splice modes may be deleted
as a result of repair.
