96
o
When the battery indicator provides wrong information.
Use the indicator information only for your information.
9.2
Splice
o
When an error message appears on the screen.
Refer to the [Error message list] for detailed information.
o
Irregular of higher splice loss.
Clean the V-groove, V-block, reflection mirror and objective lenses
referring to [Maintenance]. Replace the electrode referring to
[Maintenance].
If the fiber is twisted or bent, place the bent direction down. The
splice loss will vary depending on the cleaving angle, arc discharge
conditions and the contamination condition of fiber. If you cannot fix
the higher spice loss problem after performing abovementioned
methods, contact UCLSWIFT Co., Ltd. It is recommended to conduct
a regular maintenance of the machine once per year to ensure good
splice quality.
o
Monitor is turned off suddenly.
Press any key and check [Monitor Power Save].
o
The power of the splicer is turned off suddenly.
Turn on the splicer again and check [Splicer Power Save].
o
Unable to change arc discharge amount and time.
Summary of Contents for KR12A
