Cocoon 500 / 600
19
ENGLISH
6.4 SELECTING A BASE
The handsets can be registered up to 4 bases simultaneously.
To select a base:
1.
Enter the menu by pressing
/OK
2.
Select setup using the up
and down
keys
3.
Press OK
4.
Select SEL BASE using the up
and down
keys
5.
Press OK
6.
Select a base or select AUTO using the up
and down
keys
7.
Press OK
When selecting the base, the currect selected base in indicated by a ‘o’ sign after the base number. If you select ‘Auto’
the handset will automatically search for another base when you are out of range!
7. TROUBLE SHOOTING
8. WARRANTY
•
This equipment comes with a 36-month warranty. The warranty will be honoured on presentation of the original bill
or receipt, provided the date of purchase and the unit type are indicated.
•
During the time of the warranty Topcom will repair free of charge any defects caused by material or manufacturing
faults. Topcom will at its own discretion fulfil its warranty obligations by either repairing or exchanging the faulty
equipment.
•
Any warranty claims will be invalidated as a result of intervention by the buyer or unqualified third parties.
•
Damage caused by inexpert treatment or operation, and damage resulting from the use of non-original parts or
accessories not recommended by Topcom is not covered by the warranty.
•
The warranty does not cover damage caused by outside factors, such as lightning, water and fire, nor does it apply
if the unit numbers on the equipment have been changed, removed or rendered illegible.
Note: Please do not forget to enclose your receipt if you return the equipment.
Symptom
Possible cause
Solution
No display
Batteries uncharged
Check the position of the batteries
Recharge the batteries
Handset turned OFF
Turn ON the handset
No tone
Telephone cord badly connected
Check the telephone cord connection
The line is occupied by another handset
Wait until the other handset hangs up
The icon
flashes
Handset out of range
Bring the handset closer to the base
The base has no power supply
Check the mains connection to the base
The handset is not registered on the
base
Register the handset on the base
Base or handset do not ring
The ringing volume is zero or low
Adjust the ringing volume
Tone is good, but there is no
communication
The dialling mode is wrong
Adjust the dialling mode (pulse/tone)
Not possible to transfer a call on PABX
The FLASH time is too short
Set the unit to Long Flash time
Telephone does not react to pressing the
keys
Manipulation error
Remove the batteries and put them back
in place
Cocoon500_eur.book Page 19 Friday, June 20, 2003 2:49 PM
