BLE RS-485 Serial Adapter
user manual V1.1
- 6 -
E
Even parity
?
Inquire the current setting.
PIN=
This command is used to specify a PIN code. The default PIN is
“123456”. Paired adaptors should have a same PIN. This command is
used to specify a PIN. The default PIN is “1234” and the length is not
smaller than 4. Paired adaptors should have a same PIN. The PIN code
includes the numeral and English characters.
(Default)
123456
xx….xx
“xx….xx” is a
6 digit string or English character (in capital or lower case)
N
Cancel authentication by PIN.
R
Restore the default settings PIN=“123456”.
?
Inquire the current PIN.
PROMPT=
The command is used to decide whether result messages are prompted
when Setup commands are executed. The result messages are:
OK/ERROR for command execution.
(Default)
Y
Prompt result messages.
N
Not prompt result messages.
?
Inquire the current setting.
ROLE=
This command is used to specify whether the adaptor is in the central or
peripheral role. If the device role is changed, the adaptor will reboot and
all paired addresses will be cleared.
C
Set the adaptor to the central role.
(Default)
P
Set the adaptor to the peripheral role.
?
Inquire the current role of the adaptor.
STATUS=
Inquire all the current setting of the adapter.
T
Inquire the inner temperature of the IC in centigrade
?
Display the current setting of the adapter
STOP=
This command is used to specify one or two stop bits of COM port.
The command will need 200ms delay.
(Default)
1
One stop bit.
2
Two stop bits.
?
Inquire the current setting.
VERSION=
This command is used to inquiry the firmware version.
?
Inquire the version codes.
7. Central and Peripheral: (Similar like the Master and Slave roles)
7.1 DIP switch setting: The central will pair the slave automatically, please refer to page 2
section 2.3.
Switch DIP-9 to 0 (Switch)
Switch DIP-4 to 1 (Master)
The central will link with the neighboring peripheral automatically. The blue LED will
be solid on. The central will link with the paired peripheral on next time when power on.
Please reset to the default and follow the above procedures if you want to link with
other BLE devices.
7.2 AT command: Please refer to page 5 section 6.
