Installing
the Security System
Page 58 | August 17, 2010
L.
Configuring the TouchScreen
If necessary, perform the following operations:
•
Modify the Entry and Exit delay time periods (see page 69)
•
Modify the alarm transmission delay (see page 71)
•
Modify the “swinger shutdown” (see page
73)
Reset the TouchScreen to factory defaults (see page 73)
Note:
This will cause the device to require activation again, which in turn will require that the
customer’s account be reset as well.
•
Check for a new firmware update (see page 76)
•
Manage the sensors/security zones (see Table 6 on page 59)
•
Manage key fobs and key pads (see Table 8 on page 60)
•
Manage the cameras (see Table 7 on page 60)
Technicians can also perform the following general activities that are also available to the customer.
Note:
See the
TouchScreen User Guide
for information about these activities.
§
Manage the Quickarm settings
§
Manage the way sensors are listed in TouchScreen reports and tools
§
View and test the TouchScreen’s connectivity to the central monitoring stations (also
described in this document on page 16)
§
Manage the keypad codes and secret word
§
View the customer’s account information
§
Manage your TouchScreen device sounds, screensaver, etc
§
View technical information about the TouchScreen device
