www.uctronics.com
7
E.
ABS Protective Case Enclosure
This enclosure case is elegant, beautiful, and functional for Raspberry Pi 3 Model B.
Made of ultra-durable, super-glossy polycarbonate, it is both good looking and tough
enough to toss into your bookbag or toolbox. It has slim openings for all your cables, an
easy-to-remove beveled slot for your Micro SD card, slots for both your Pi camera and
upcoming display, and a space for your GPIO cable to extend out from the Pi.
Specification:
Durable two part ABS plastic case
Large internal volume for HATs, break-out boards, or heat sinks
Vents on three sides double as fly-through cable ports
Two-section breakout on A/V side for break-out board I/O
Micro SD card access port
Mounting option 1: two M3.5/M3/#6 screws slide into wall mounts for easy removal,
horizontal orientation with A/V side down, 40mm spacing
Mounting option 2: four M3.5/M3/#6 screws through feet from inside for secure mounting in
any orientation, 68.3 x 38.8mm spacing
External dimensions: 96 x 66 x 41mm
Internal volume for breakout boards:
Length: 90.0mm
Width: 60.0mm
