MR-400/M
1
2
3
4
Alojamiento baterias
Sensor IR
On / Off
Display LCD
3
2
4
1
We recommend checking the battery level of the MH-403 microphone before
of its use, consulting the display of the MH-403 microphone itself.
610 567A
.
Rev.1
3 / 3
Preliminary
- Screw in the two antennas on the rear panel and place them in a vertical position for a better reception of the
signal.
- Connect the included power supply to the MR-400 receiver.
- Connect the audio cable to the output on the rear panel. XLR (balanced) or 6.35mm Jack.
Frequency synchronization
- Turn on the wireless microphone MH-403.
- With the receiver on, press the
SET
button two times in a row.
The channel indicator on the display of the MR-400 receiver
will blink.
- Select the frequency (channel) using the buttons
UP
and
DOWN
. Once the selection is made, press
SET
. The channel
will be memorized and will be shown in a fixed form.
- With the wireless microphone about 10-15cm from the receiver, press the
SET
button on the receiver to start the
synchronization. During this process
SYNC
will be shown on the MR-400 display.
- The pairing process will end when the same frequency appears on the MH-403 microphone display.
- To automatically search for a free or low interference channel, press the
ACT
button, the receiver will scan of channels
and will stop at a free one. While searching,
SCAN
will be displayed on the screen.
To adjust the microphone gain, press the
UP
and
DOWN
buttons on the MR-400 receiver.
Microphone gain adjustment
