INSTALLATION
STEP 1: INSTALLING THE FAUCET
1) Pass the small rubber washers, the chrome base plate and the large rubber washer in that order over the
threaded mounting tube at the base of the faucet.
2) From under the sink, install the large metal (or plastic) washer and the star washer over the threaded stem.
Screw on the nut and tighten.
3) In the parts bag locate the plastic female threaded quick connect faucet adapter fitting. Thread it on to the
faucet stem - be careful not to overtighten as it may crack the fitting.
Please see <Fig. 1> and <Fig. 2>
<Fig. 1>
<Fig. 2>
5
Non Air-Gap Faucet
4) In the parts bag, locate the blue 1/4” tube. Connect one open end
of the blue tube to the RO faucet 1/4” quick connect fitting making
sure the tube is pushed in all the way to the tube stop.
5) Connect the other open end of the blue 1/4” tube to the elbow
fitting on the back of the RO module labeled “FAUCET” making
sure the tube is pushed in all the way to the tube stop.
Rear View of the KC5000 System - Connections
