UDO Super 6 — Owner’s Manual
120
Calibrating DDS 2’s TUNE Control
Follow the steps below to calibrate DDS 2’s
TUNE
control:
1.
Turn off the Super 6.
2. Turn on the Super 6 whilst holding the
TUNE
button (bank select
button
F
).
3. Whilst continuing to hold the
TUNE
button move the
MIX
rotary
control to make DDS 2 audible.
4. Play any note and move DDS 2’s
TUNE
rotary control to a point
where both DDS 1 and DDS 2 sound in tune.
5. Release the
TUNE
button and the key you played.
6. Move DDS 2’s
TUNE
control to
+6
, then back to the centre.
The oscillators should now be in tune.
7. Don’t play a key or move a control for about 30 seconds to save
the calibration setting.
Setting up the Super 6 as a MIDI Device
in a DAW
Follow the steps below to use your Super 6 in conjunction with a DAW:
1. Connect the Super 6 to the MIDI ports of your audio interface (in
case your audio interface is equipped with MIDI ports) or the USB
port of your computer.
2. Once the Super 6 is connected to your MIDI-equipped audio
interface or your computer, ensure that your DAW sends and
receives the MIDI data you would like the Super 6 to receive and
send via the MIDI ports of your audio interface or the USB port of
your computer. Note that if you connected the Super 6 via its MIDI
ports, you can’t select the Super 6 as the MIDI device directly, but
only the audio or MIDI interface the Super 6 is connected to.
3. Ensure that the correct MIDI channel is set up on all devices.
4. Set the global parameter
LOCAL to ‘off’ to avoid any MIDI loops
during recording and playback.
Summary of Contents for SUPER 6
Page 142: ......